Hello,
I have trouble using the MSP-GANG Programmer + MSP-GANG Splitter.
When toggling the Vcc on/off in the MSP-GANG Programmer software, I measure the voltage go on and off on pin#12 on the JTAG/BSL sockets, but according to http://www.ti.com/lit/ug/slau358c/slau358c.pdf fig 5-5, this pin is supposed to be used for BSL-TX.
Have I missed something? Is anyone else experiencing this?
I do not measure any voltage changes on pin 2 as expected.
(I am using the MSP-GANG Programmer, NOT the MSP-GANG430)
Best regards.