I just purchased an XDS200 debug probe. I have been successfully using an Olimex xds100v2 device but wanted a faster device. The target is a custom board with a TM4C1294 Tiva processor. Using CCS version 6.1.3, the connection is JTAG, the program is using TI-RTOS. The Test Connection test shows an OK scan test. However when I try to run the program (again, no problem using the XDS100v2 probe) i have no breakpoint response and no system_printf output. If I hover over the debug icon it reports that it is running. The pause button is grayed out. CCS is running in a Windows 10 Pro OS environment.
To say that I am at my wits end is an understatement :(.