Part Number:TDC1000-TDC7200EVM
I am attempting the get the TDC1000-TDC7200EVM to work with the basic level sensing application. My board is connecting properly to my PC and I can read temperature, but the average temperature I am reading is around 4000 degrees C and I only get a TOF value of 0. When the start graph button is clicked in the graph tab, LED D2 and D3 blink, green and red respectively.
My setup is modified slightly in that I am using a 3d printed box instead of the clear box shown in the video demonstration, and I am using a Steminc Piezo Ceramic Disk 1MHz (part number: SMD15T21R111WL) instead of the included transducer.
Below are photographs of my physical setup:
The connections seem good, assuming they are in the right spot, I just stripped the wires extra.
Here is a screen shot of my configuration tab:
And here is the configuration tab for the TDC7200:
I think my problem is in my configuration, but I don't know where to go to figure out how to fix it. I have been reading through all the documentation I can find but am coming up empty. Thank you so much for your time and assistance.