Hi everyone,
I'm not sure where to put this post and end up here in C6000 Single Core DSP division.
I've recently bought a OMAP-L137 Rev I as replacement of my Rev D board that faulty from Spectrum Digital.
No problem with my project, but after running my codes in a few minutes (sometimes longer), I received "Power failure on target CPU". I've tried to change my USB port and it still happens but after a longer period of time. Sometimes the message showed at ICEPICK and sometimes at C674X (ICEPICK_C: Power Failure on Target CPU or C674X: Power Failure on Target CPU.
I'm wondering whether my .ccxml was configured correctly.
In my project, I'm only using the C6747 core, so is it necessary to load .gel only for the C674X and leave blank for ARM9_0 initialization script ? How about ICEPICK_C ? Is there any initialization script/gel for it?
I hope it is not related to power or device failure because it takes time to get replacement and I'm running out of time now. Hope someone can help.
Note: I'm using CCSV5.3.0.00090 with CGT 7.2.0 (I know it is old but since I'm using RTFS 1.10.2.32, this is the higher version that is supported), with the latest Spectrum Digital Emulation/Driver.
Kind regards,
Rizuan