Dear Community,
we have some issues using the F28069 ControlCard.
We have built two .out files of a simple "HelloWorld" Programm (toggeling GPIO31) using Matlab Simulink R2013a following the instructions in this video: www.youtube.com/watch?v=AY4GzMLl30A
The difference between the two .out files is that one is for a ROM Boot (which works fine if we load it to the F28069 using CCS 5.4) and the other one is intended for Flash Boot. We have loaded this second one to the controller using CCS 5.4. The load process seems to work o.k. (no errors) but the program does not run.
Are we missing anything obvious? I have attached the two .out files if someone can check if the hex files are the problem or if something else is not working as intended.
Thanks in advance
Christian