Circuit 3 on my bq76pl536evm-3 board has been working fine for awhile now that I have been using it. I have been using a 4 channel power supply to put a voltage on each circuit while learning to send SPI messages to my CAN eval board. The power supply can not go higher than 20 V on the highest channel and the IC's on the board can take up to 30 V I believe. The other two circuits work perfectly fine still. When I attach the negative to the negative end and the positive to cell 6 I usually get the same voltage on each sell. For example, I put 12 V across it each would read 2 V. Now on circuit 3 I have 18 V for the brick voltage but the cells are all over the place. I know the resistance on cell 3 is different the rest and the other resistance have changed too. The 1k ohm resistors are okay. The reading for the wrong voltages start right at the mating terminal blocks that attach to the headers. Trying to troubleshoot what is wrong but not able to find anything yet. Any suggestions?
↧