Hi,
I have my own board with CC430F5137 working flawlessly at 433 MHz with 2-FSK and MSK at 250 kbps. However when I change to OOK at 250 kbps I am not able to receive anything on the other boards. I've used the SmartRF studio to obtain the proper register values, but it does not seem to work. I think I am overlooking something obvious but right now I cannot find what, so I'm stuck. Could you please check my register configuration settings and provide some feedback? Thanks in advance!
0x1E, // IOCFG0 GDO2 Output Configuration
0x29, // IOCFG2 GDO1 Output Configuration
0x07, // FIFOTHR RX FIFO and TX FIFO Thresholds
0x84, // PKTCTRL1 Packet Automation Control
0x05, // PKTCTRL0 Packet Automation Control
0x0F, // FSCTRL1 Frequency Synthesizer Control
0x00, // FSCTRL0 Frequency Synthesizer Control
0x10, // FREQ2 Frequency Control Word, High Byte
0xA8, // FREQ1 Frequency Control Word, Middle Byte
0xA0, // FREQ0 Frequency Control Word, Low Byte
0x2D, // MDMCFG4 Modem Configuration
0x3B, // MDMCFG3 Modem Configuration
0x33, // MDMCFG2 Modem Configuration
0x22, // MDMCFG1 Modem Configuration
0x10, // MDMCFG0 Modem Configuration
0x62, // DEVIATN Modem Deviation Setting
0x30, // MCSM0 Main Radio Control State Machine Configuration
0x1D, // FOCCFG Frequency Offset Compensation Configuration
0x1C, // BSCFG Bit Synchronization Configuration
0xC7, // AGCCTRL2 AGC Control
0x00, // AGCCTRL1 AGC Control
0xB0, // AGCCTRL0 AGC Control
0xB6, // FREND1 Front End RX Configuration
0x11, // FREND0 Front End TX Configuration
0xEA, // FSCAL3 Frequency Synthesizer Calibration
0x2A, // FSCAL2 Frequency Synthesizer Calibration
0x00, // FSCAL1 Frequency Synthesizer Calibration
0x1F, // FSCAL0 Frequency Synthesizer Calibration
0x88, // TEST2 Various Test Settings
0x31, // TEST1 Various Test Settings
0x09 // TEST0 Various Test Settings
Kind regards,
Pere