Part Number: CC1352P
Hi,
I am putting together a circuit primarily based on the CC1352P and would like to expose the UART interface via FTDI's FT231XS-R USB to Serial IC - so I can power and communicate via my computer's USB port. The circuit I have put together is as follows:
Is it sufficient to only expose the RX and TX channels as I have done, or do I need to expose additional channels for handshaking / initialisation / resetting? I am guessing this would be dependent on the capabilities of the UART driver.
I will be programming the chip via cJTAG, so the USB interface is only for power and Serial / UART communication with the CC1352P.