Part Number: BQ40Z80
Hi all,
I have an issue with LED blinking option for state of charge, in fact I have this result :
(assuming the segmentsprogrammed are 0%, 20%, 40%, 60%, 80%, and 90% of RSOC), the state-of-charge ranges are as
follows:
95 to 100% LED6 on blink, else LED6 off, if SOC is lower %
90 to 95% LED6 on SOLID
85 to 90% LED5 on blink
80 to 85% LED5 on SOLID, else LED5 off, if SOC is lower %.
70 to 80% LED4 on blink
60 to 70% LED4 on SOLID, else LED4 off, if SOC is lower %.
50 to 60% LED3 on blink
40 to 50% LED3 on SOLID, else LED3 off, if SOC is lower %.
30 to 40% LED2 on blink
20 to 30% LED2 on SOLID, else LED2 off, if SOC is lower %.
10 to 20% LED1 on blink
0 to 10% LED1 on SOLID
Finaly, blink and solid mode are reversing !
Did you have a solution for have the normal mode like TRM §9.1.6 ?
Best Regards,
Loïc