Hello,
I would like to do several tests with a DAC5675AEVM driven by a TSW1400EVM. I know that just
the CMOS port can be used because there is no DAC5675A .ini file and no firmware. I also know that
there is a speed limit of about 250 MHz, but this would be ok with me.
Q1: What do you suggest to interface the CMOS output pins of TSW1400 to the LVDS input pins
of DAC5675A board ? I assume an adapter PCB with a LVDS driver would be the best choise, right?
Q2: What is the setup procedure for HSDC Pro to generate signals at the output of the DAC board?
I did not find detailed description of what to do in this particular case.
Would be nice if anybody could advice.
Thank you.
Robert