Part Number: AWR1843BOOST
Tool/software: Code Composer Studio
Hi.
I recently got a mmWave AWR1843BOOST kit. I tested few debuggings were all fine.. But I thought of erasing using UniFlash Erase SFlash option and after the device stops responding. I always get this error when i try to upload and debug via CCS.
Error connecting to the target:
(Error -2062 @ 0x0)
Unable to halt device. Reset the device, and retry the operation. If error persists, confirm configuration, power-cycle the board, and/or try more reliable JTAG settings (e.g. lower TCLK).
(Emulation package 8.3.0.00003)
I am defenetely aware of Flash mode, function mode and debug mode and i never mismatched or experimented with them. What went wrong with this ?