Hello,
I am trying to erase the MT29F4G16 Flash using your Flash v1.6.0.0 program. I am successful using the RS232 UART. But I am not successful when I select USB. My set-up is as follows: My target is AM37xx (Micron), Memory type is NAND, ONFI compliant is checked, 1-Bit ECC layout Layout X-Loader/U-Boot, and I am using the TI TPS65930 with ID (pin G6 floating) VBUS connected to USB_VCC. The TPS65930 UCLK (K11) is connected to HSUSB0_CLK/GPIO_120 of the AM3703CUS, DIR (H11) is connected to HSUSB0_DIR/GPIO_121 of the AM3703CUS, STP (H12) is connected to HSUSB0_STP/GPIO_122 of the AM3703CUS, and NXT (J8) is connected to HSUSB0_NXT/GPIO_124 of the AM3703CUS. When I power I get “USB Device Not Recognized”. Any suggestions? Cliff