TLK1101E: Validate LOSL, LOSR, VTH implementation is correctly implemented and understood

Part Number: TLK1101E

Hi,

I am planning on controlling the LOS pins by using SCL/SDA as the control mode and I will be connecting these SCL/SDA pins to an FPGA with pullup resistors.

 For the other pins, I am planning on doing the following even though I will be using SCL/SDA as the control mode:

• LOSL = open, to have it default on powerup to the lower LOS assert threshold voltage even though I plan on setting register address 0 bit 0 for the serial control mode
• LOSR = connecting to FPGA to be configured
• VTH = open, for default 0V differential threshold.

Let me know if you see any problems with this approach or if this is correct.  

Thanks,

HSG