C2000-GANG: Using C2000 Gang Programmer for Controlled Code Flashing

Part Number:C2000-GANG

Hi all,

For our product we have a royalty mode where Firmware is the control parameter. The Code is being manually flashed at the moment and adding a bootloader to the code is not feasible at this time. We wish to use C2000 Gang Programmer to do the same. 

Please confirm if I can do the following with the C2000 Gang.

1. We need to set the number of times the code needs to be flashed. Beyond this number, the instrument should not flash
2. The Manufacturer must not be able to access the code. The code should be in internal memory and password protected
3. Should be able to renew the licenses over Internet

We need to know these info before we go ahead and buy one.

Expecting a reply soon... thanks in advance.

Santhosh