Part Number:CC2650
I installed the 6lbr service on my raspberry pi (Raspbian Wheezy is installed) and and following configurations were added to the /etc/6lbr/6lbr.conf file and run the 6lbr service. Slip radio configured CC2650 launchpad is attached to the pi. I received a message "starting 6LoWPAN border router". When I checked the log file, it shows "6LBR: CETIC 6LBR Started" at the end. I changed my PC's eth0 interface address as bbbb::101/64 and used Firefox to access the web server page. (Ubuntu 14 is installed). But I could not access the web-page. And also tried to ping to the bbbb::100 but it also did not work. What would be the reason for that? Any suggestions to overcome this?
MODE=ROUTER
RAW_ETH=1
BRIDGE=0
DEV_BRIDGE=br0
DEV_TAP=tap0
DEV_ETH=eth0
RAW_ETH_FCS=0
DEV_RADIO=/dev/ttyACM0
BAUDRATE=115200
LOG_LEVEL=3