Part Number:TM4C1230E6PM
Hi community,
Please help me to find the solution for the below queries:
1) Please provide the brief information about the JTAG daisy chain configuration.
We are using TI CC1352 and TI TM4C MCU in our design & we planned to flash both chips by using JTAG Daisy chain configuration.
Please refer the attached image.
a)We set CC1352P reset to 10ms by using RC circuit and TM4C reset to for 1ms. Since there is no additional JTAG resets for each IC. Those IC resets signals have to be controlled by JTAG TAP port ?
How it will be synchronized ? Both IC reset has to be shorted ?
b) In this daisy chain set up requires any additional pull up & pull down resistors (Termination resistors) on JTAG IOs ?
c)Is it possible to flash any one of the MCU by using Bypass mode of the other ?
Thanks & regards,
Divya