Part Number:TMS320F28379D
Tool/software: TI C/C++ Compiler
Hi,
I am new to TMS320F28379D , these are a few doubts i have ...
1.what is the input and output buffer of this program?
2.How to make a connections to this program ,am not getting this part ,can you please explain.. this was given in the program
" EPWM1 and 2 are setup such that EPWM2 outputs a square wave at a frequency 10 times slower than EPWM1; EPWM1 serves as the sample clock to the ADC which will sample EPWM2A (pin 53) through channel A0 (pin 09) and then run the FFT. "
3.can we give input signal directly from signal generator instead of Epwm?
4.where and how FFT is implemented in this program?
5.How to add RUN option in our ccs8, as i want to check cycles of our program.
Below i have attached image
Regards,
Ashwin
