Hi,
When I tried to configure as AP through application, sometimes I am getting following error.
=================================================
wlcore: PHY firmware version: Rev 8.2.0.0.212
wlcore: firmware booted (Rev 8.9.0.0.17)
IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready
IPv6: ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready
Configuration file: /etc/hostapd.conf
nl80211: Could not configure driver mode
nl80211 driver initialization failed.
hostapd_free_hapd_data: Interface wlan0 wasn't started
=================================================
Any suggestions would be really appreciated.
Regards,
Ijaz Fazily