TDA2: Vision SDK TDA2xx v03.02.00

Part Number:TDA2

Hello everyone:

Here are my environment:

Hardware:

1. TDA2xx EVM
2. TDA2xx Vision Application Board 
3. 6 channel FPD-Link III FMC Daughter Board
4. 2 x OV10635 Sensor

SDK: Vision SDK 3.0.2

I can run use case "vip_single_cam_sgx_display" with single OV10635 connected to P1.

Now, I'm trying to run use case "lvds_vip_multi_cam_view_sgx_display". BUT when I'm using daughter board that two OV10635 camera connected to, the kernel stop at "[  OK  ] Started Synchronize System and HW clocks." and then reboot again and agin. I try to remove one of the camera and there is no problem at all. And I also try to use Automotive SDK, the result is the same.

My question is "Can I use only two cameras? How can I do that?"

Thanks in advance