Quantcast
Channel: Forums - Recent Threads
Browsing all 262198 articles
Browse latest View live

CC1310: wmbus,send data fail

Part Number: CC1310when I use wmbus-T mode fast send data,about 200ms interval,one hour later,the receiver can not receive data again.so i think the send data operater is fail.

View Article


UCD3138: Telecom power market trend

Part Number: UCD3138Hi Team,I am not sure if this is a right forum to ask telecom power market trend related questions. My customer is making telecom fans and would like to know some related...

View Article


Image may be NSFW.
Clik here to view.

INA333: INA333 ECG

Part Number: INA333The circuit was tested according to the figure above. The ECG signal can not be detect.But the interference signal of 50HZ can be detected by Oscilloscope.Can you give the relevant...

View Article

ADC101S021: ADC101S021 Referece Code

Part Number: ADC101S021Hi,We've one project which uses ADC101S021, however, we cannot find out reference code for this ADC.So Could you share the reference code for us?Thanks,

View Article

Compiler/IWR1642: Why only 7.4.16 can work for ppc and TM demo

Part Number: IWR1642Tool/software: TI C/C++ CompilerHi,For people counting, traffic monitor demo, why only CGT 7.4.16 can work, while other update version such as 8.1.3 still cannot work? Do BU find...

View Article


Image may be NSFW.
Clik here to view.

AM3358: MDIO cann't find PHY ID

Part Number: AM3358We have a design with am3358  and  two AR8035,the two AR8035 PHY ID is 4 and 6,  the schematic is shown below. During the aging test of Ethernet, sometimes we found that the mdio bus...

View Article

Image may be NSFW.
Clik here to view.

DRV8813: Why we need to to use the 1Mohm resistor here?

Part Number: DRV8813Hi team,Why we need to to use the 1Mohm resistor here?  Thanks. 

View Article

TMS570LC4357: emac driver not work

Part Number: TMS570LC4357I blocked by emac driver on LC4357 develop board,  It seems has no emac driver.I gererate emac & system driver with HALCoGen 04.07.01, then do some modification according...

View Article


Image may be NSFW.
Clik here to view.

TPS7H2201-SP: Vin Enable

Part Number: TPS7H2201-SPTeam can you help confirm the below:What does the second from the bottom row mean – VINEN?  The 75%?  Does it mean that if I am switching 5V.  75% of 5V is 3.75V, do I need a...

View Article


PCM2912A: Please support us for Land pattern of PCM2912APJT

Part Number: PCM2912AHi TI,We are designing USB Audio with PCM2912APJT.However, in this datasheet you don't provide land pattern.Please support me!Best Regards,

View Article

Image may be NSFW.
Clik here to view.

TPS1663: TVS and schottky diode

Part Number: TPS1663HiMy customer has question."TVS" and "schottky diode" in Figure 38 of the data sheet. How should I select them if I want to mount them?The specifications assumed by customers are as...

View Article

Image may be NSFW.
Clik here to view.

CCS/LAUNCHXL-CC2650: Example Code for AES and SHA256

Part Number: LAUNCHXL-CC2650Tool/software: Code Composer StudioHi,is there any example code aout the AES and the SHA256?i can't find any info about it with the TI Resoutce Explorer:Thanks,LN 

View Article

LM43602: FB Resistor

Part Number: LM43602Hello,I have a question about FB resistor selection.The datasheet recommends RFBB=43.2kohm when Vout is 24V. (RFBB is connected FB to GND.)Is it possible to choose RFBB=4.32kohm...

View Article


Image may be NSFW.
Clik here to view.

TPA3251:Help

Part Number: TPA32511. FAULT output of TPA3251 is measured to be at high level of 3.3v, while the RESET of TPS3802 is always at low level, so TPA3251 cannot be started.2. When the MR of TPS3802 is...

View Article

DLP7000: DMD window replacement

Part Number: DLP7000I am working on building a Infrared Projector with the DMD.However the DMD windows are only available for Visible and NIR wavelength.Could someone help me where I can replace the...

View Article


TPS82130: Pre-biased Output Condition

Part Number: TPS82130Hi Power Experts,I have a use case where the TPS82130 is generating a 2.5V output. The enable is connected to the VIN supply. The device can be running and fully charge the output...

View Article

INA133: Major technical/specs differences between INA133UA & INA133U

Part Number: INA133Dear Team,We are using INA133U in one of our major project where as can we use INA133UA without any changes. If we use INA133UA  instead of INA133U, will affect my circuit anywhere...

View Article


FDC1004: Evaluation results and operating principles

Part Number: FDC1004Hi.I have a question.When measuring the volume of conductive liquid or water using this IC, is there a possibility that the measured value will be smaller than the result measured...

View Article

CC3220MODA: Is it possible to use integrated antenna or external antenna by...

Part Number: CC3220MODAHiIs it possible to use integrated antenna on CC3220MODA or external antenna on board by changing configuration or  something dynamically?If the answer of above is YES then how...

View Article

BQ24193: Charge operation problem

Part Number: BQ24193Dear Ti supportI'm Sesumi  from Japan.I have a question about charge operation.After precharge operation, I saw an abnoromal operation, in which current reached about 1A~2A for...

View Article
Browsing all 262198 articles
Browse latest View live


<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>