Hi,
I am using eZ430-RF2500-SEH and need to set the datarate to lower than default value of 250Kbps. This should allow the transmission range to be improved. However, in the SmartRF stuidio, there are setting only for 2.5Kbps, 10Kbps and 250Kbps. I would like to have some suggestions if any of you have some setting for 125Kbps or 62.5Kbps.
The other problem is that as data rate is reduced and transmission time extended, the supply voltage will dip. It seem like receiver is not able to receive properly a message send. I thing as supply voltage dip during transmission, it have some impact on the RF signal quality of CC2500. Do any of you encounter such issues? Please share with me...
Thanks in advance.
ST