CCS/MSP430FR2633: Captivate Design Center only support MSP430FR2xxx types.

Part Number:MSP430FR2633

Tool/software: Code Composer Studio

Dear all:

I want to use MSP430 series to design capacitance sensing. With the FR2633 development board (www.ti.com/.../MSP-CAPT-FR2633)  and the CapTIvate Design center GUI, it becomes much easier to develop cap sensors. Thanks for your efforts.

While I found that there were few types of devices that can be selected from the Design GUI, which are FR2xxx series, as shown in the figure below.

I looked over other MSP430 series devices, for example MSP430FR5969), which also support Capacitive touch capability, but was not listed in the list.  I found that in those datasheets the capacitive touch I/O principles are the same. So, is there any convenient way to develop code for MSP430FR5969 like with FR2633? Is it possible to apply the Design GUI software to device FR5969?

Thanks very much.

Regards,

Qi