Part Number:TDC1000-TDC7200EVM
Hi everyone.
I am developing and a project and using TDC1000-TDC7200EVM board and GUI for test
When start a measurement with single shoot or debug tab or another, there no signal on stop path (I traced it with 1000 Mhz oscilloscope and 24 Mhz logic analyser)
It may be normal because my transducer are very far each other.
My problem; on GUI there is no changing TDC1000 error flag and TDC7200 int status...
Why does not error flag or int status change?
NOTE : NUM_RX and NUMBER_OF_STOPS is 5 (five) on TDC1000 and TDC7200 respectively.