BQ20Z95: bq20z95 SubClass of 'IC part number' in DataFlash Classes

Part Number:BQ20Z95

 Dear support,

While programming bq20z95 through DataFlash SubClasses me can not figure out appropriate SubClass and offset for 'IC part number' which should be returned by Manufacture Access sub command 0x0001.

The same is for Manufacture Access subcommands 'Firmware Version' 0x0002 and 'Hardware version' 0x0003 which all are Read-only and couldnot be edited.

Datasheet also refers to SBSCommand Manufacture Data 0x23, where it's possible to Read/Write parameters like PCB Code, H.Ware and F.ware versions but in DataFlash programming manual me found that these values, DataFlash Subclass 58, are just for information and couldnot be relied upon when referencing to Device Type, Hardware and Firmware versions.

Kindly advice how to correctly programm required values through DataFlash SubClasses commands.

Thanks a lot for reply!