Part Number:DS125DF410
Hi,
My cusotmer is using DS125DF410.
He has a issue of CDR unlock (LOCKx pin is low).
His system has "the register configuration procedure" of datasheet page 16.
But He has unlock this condition.
Next, He added setting of 0x24 address = 0x42 after "the register configuration procedure".
Then, He could has lock condition.
What is the cause of this issue?
Why was this issue resolved by setting of 0x24 address = 0x42 after "the register configuration procedure"?
Could you give me advice, please?
Best regards,
Shimizu