Part Number:LAUNCHXL-CC2650
Tool/software: Code Composer Studio
Hallo good afternoon from indonesia, I am developing a CC2650 based device, I am using a CC2650 Custom Board with XDS110 debugger from Board LAUNCHXL CC2650, I have almost finished 10 pieces of chip due to malfunction, and I am almost desperate with this problem,
1. what is the cause of pin DCDC_SW when measured its value is not 1.6V?
2. SmartRF Flash Stduio always does not detect device CC2650?
3. When I measure in Pin DCDC_SW the voltage value is 2.8V, what is the cause?
when I do the measurement by mounting the multimeter probe from Ground to the inductor DCDC_SW Pin, the CC2650 CHIP is damaged immediately,
Sorry my English is Not Good,,
Thanks