TMS320F28377D: eCAP rising edge detection

Part Number:TMS320F28377D

Hi all,

I use GPIO24 as eCAP input pin and configure eCAP for rising edge event, should I follow electrical parameters of GPIO24? The minimum VIH = 2.0V and maximum VIL = 0.8V?

If the answer of statement above is positive, I will have the questions below,

• Does it mean when the voltage input on GPIO24 change from 0V to 2.0V, it will have an eCAP event?
• Is there any voltage rising time spec?
• No eCAP hysteresis, is this correct?

Please advise your idea if any, thanks.

Regards,

Luke