Problem with Spy-bi-wire programming

I am using the demo board MSP-TS430RGZ48C with a MSP430FR5969 and the debugger MSP-FET430UIF. For programming the device, I use the last IAR version (5.51.3). When I place the Jumper JP3, JP4, JP5, JP6, JP7 and JP8 in JTAG mode I get to program and communicate with the MSP430 successfully, but when I change the jumpers in SBW (Spy-Bi-Wire) position,  I cant to program the device and I get the message “Fatal error: Could not find device (or device not supported)   Session aborted!” in IAR.

I have proved to configuring in IAR Debugger options => Debug protocol the options “Automatic selection” and “Manual selection => Spy-bi-wire” and I get the same result.

Is there something else to configure in the demo board or IAR?

 Thanks.