Part Number:AWR1243
Hi,
My customer wants to use radar studio to configure AWR1243 on own board to verify the radar chip works or not.
In radar studio, it needs to connect UART and SPI. I think UART is to use download the firmware and SPI is using to send the radar command. Right?
1. On customer's board, customer connects the UART pin of AWR1243 (N6/N5) to external RS232 chip directly and then connect to PC with serial cable. For SPI, customer fly-wires the SPI signal on own board to dev pack board and connect the usb cable with Dev pack and PC. Are these HW connection enough for using radar studio?
2. Customer set the SOP to 010 by HW pull-up/pull-down. Can customer skip the SOP setting in radar studio?
Any other things customer need to take care for this use case?
Thanks,