Hi
I have a board which is configured boot from SPI0 flash, I generated the bin file via AISgen, after I burned the flash and power on the board, the clock of SDRAM is correct as I desired , and I also can see the CLK/CS/SI/SO signal via oscilloscope, but it seems my application code wasn’t loaded to the RAM of DSP, the led can’t blink as I emulated via XDS560V2plus.
I also configured the board booted from UART, use the same .out file to generated the new file for UART boot, the application code can work, the led can blink.
My question is:
- I can boot from UART and application can work, it means that my .out file is correct.
- Use the same .out file to generate .bin file for SPI0 Flash, then the SDRAM can work as I configured, at least the CLK is correct
- I also can see the CLK/CS/SI/SO signal of SPI0 flash.
- Why it seems that my application code cannot be loaded to DSP or it cannot work (the led doesn’t blink)?
My flash type is MX25L3206E.
Can you give me some suggestion or hint? What’s wrong here?
Angela