Part Number:BQ34Z100
Hello-
We are trying to calibrate the fuel gauge bq34z100g1 as shown in the EVM datasheet :http://www.ti.com/lit/ug/sluu904a/sluu904a.pdf
In the voltage calibration step we get the following error: see(Please visit the site to view this file) attached.
We have two questions regarding the same:
1. When we enter voltage across bat+ and bat- which is 22,000 mV, we get the error: Calibration cell voltage entered is out of range. This value is in millivolts. Please check value and retry.
Should this be voltage per cell, in our case 22,000/6 as we have a 6s battery?
2. When we enter the per cell voltage, i.e. 3666 mV it starts calibration but errors out with error:
Calibration-A read of data written failed comparison.
How can we avoid and correct this error?
Thanks, and Best Regards,
-Tim Starr on behalf of AB@AR