When I’m working on High Voltage Motor Control and PFC kit(TMDSHVMTRPFCKIT)(new Version Kit) with PMSM motor following Problems I have been facing.
- While demonstration GUI for PMSM along with above mentioned board we have encountered problems.
- Steps are followed as per the Quick Start Guide.
- Got connected in the GUI
- When enabling the motor it starts Spinning in one direction later after two rotations, Motor starts to spinning in other direction.
- Motor is also getting heated.
- Immediately we are getting over current error in the GUI window but when we measured the current is very low, say around 3A.
- When we performed Single step Debug using Code Composer Studio(followed as per the document in ControlSuite),
- For level-1 all the waveforms are properly coming and level-1 successfully verified.
- For level-2, Level-3 & level-4 we are unable to see consistent results. For every build we perform we are getting different results(Motor Stalling and giving vibrations).