Part Number:LAUNCHXL-CC1310
Hello All,
I am trying to test the viability of using the 1310 in a production device. I have purchased a cc1310 LaunchPad rev: 1.4 to test a few things out. My biggest hangup now is my in ability to program it without using the built in XDS probe. I was under the impression that i code hook my ftdi programmer up to the uart pins on the 1310 and run the bootloader pin to GND and i would be able to flash the board. Windows is assigning it a com port, but anytime i try to program it i get nothing. I have read through the forums and read a bunch of there guides to using the serial bootloader but none of them seem to be getting me any closer to solving this problem. Please Advise.
Thanks for any help