Part Number:TMS320F280049M
Tool/software: Code Composer Studio
When I started writing ADC module program in TMS320F280049M, I met a problem. TI has given an example to how to set up ADC REF during ADC initialization program in f28004x_adc.c. the code is as follow:
void SetVREF(int module, int mode, int ref)
{
Uint16 *offset, offval;
offset = (Uint16 *)(0x70594 + (module * 6));
if((mode == ADC_INTERNAL) && (ref == ADC_VREF3P3))
{
offval = (*offset) >> 8; // Internal / 1.65v mode offset
}
else
{
offval = (*offset) & 0xFF; // All other modes
}
EALLOW;
switch(module)
{
case 0:
AdcaRegs.ADCOFFTRIM.bit.OFFTRIM = offval;
AnalogSubsysRegs.ANAREFCTL.bit.ANAREFASEL = mode;
AnalogSubsysRegs.ANAREFCTL.bit.ANAREFA2P5SEL = ref;
break;
case 1:
AdcbRegs.ADCOFFTRIM.bit.OFFTRIM = offval;
AnalogSubsysRegs.ANAREFCTL.bit.ANAREFBSEL = mode;
AnalogSubsysRegs.ANAREFCTL.bit.ANAREFB2P5SEL = ref;
break;
case 2:
AdccRegs.ADCOFFTRIM.bit.OFFTRIM = offval;
AnalogSubsysRegs.ANAREFCTL.bit.ANAREFCSEL = mode;
AnalogSubsysRegs.ANAREFCTL.bit.ANAREFC2P5SEL = ref;
break;
default:
break;
}
EDIS;
}
when the ref voltage in ADC module is 3.0 V with external reference mode, in my opinion, I should set parameter of mode in this function with ADC_EXTERNAL, however, the ref voltage is 3V not 2.5V and 3.3V, how should I to configure AnalogSubsysRegs.ANAREFCTL.bit.ANAREFC2P5SEL = ref, that is how to configure the parameter of ref in fuction.
Another question is when I saw the data sheet ， I found a ANAREFPP Register in AnalogSubsysRegs which is related to how to configure the ref voltage of A、B and C module, and its description is as follow
I wonder if I use TMS320F280049M with 64pins , ANAREFBDIS bit in ANAREFPP register is whether shoulde be congfigured in ADC initialization.
thanks！
Best regards!