I used CCS 5.3 and it was such problems. After windows boot, first attempt to debug leaded to some strange condition of CCS when one part of interface is in debug mode, but other part in editing mode. I closed CCS and restart and debuging started good. I made autoupdate and now have CCS 5.4.0.00091. I can't to start debuging not in first and other CCS load. I make attempts in on BH USB 510L, XDS100v2 and XDS100 integrated in Docking-Stn USB-EMU with F28069 control card.
When I press F11, CCS check execution and Launch debug session and load application. After that I expect that cursor must point on the first command. But cursor don't appear on screen and Run menu remains as in edit mode. If I press F11 second time, CCS ask me about terminate debug session.
How I can solve this problem?