The statements under IF(condition) is shown as executed even if the condition is not met !

Hi,

i am using sys/bios 5.2 (shipped in CCS 5.2) for my project.And TMS320F28335 DCS for the same.

I CLEAN build my project,and DEBUG it. I reset the CPU ,RESTART, RESUME the excecution.And put a break point in my desired location.Here The statements under IF(condition) is shown as executed even if the condition is not met !!.

on that these were the findings i got.....

findings:

       Though the condition was NOT TRUE,the execution statements within that IF were SEEN to be executing.But the good thing is, functionalities were not happening.

For example if a variable is assigned with constant ,it was not assigning,but showing it was been excecuted in IDE. when i look into DISASSEMBLY that also showed me excecuting properly.

Thanks and regards,

Sunil