Hi TI,
In my design, Rmode on DES is 0 ohm, Rmode on SER is 100K ohm. REG[0x1F] on DES is 0x00; REG[0x05] on SER is 0x10. That is :913Q in "PCLK from imager" mode; 914Q in 12bit LF mode. Is it all right?
Bit3 and Bit2 of REG[0x35] on 913Q is the status of mode select pin according to the datasheet page 27. But the dump value are all zero. Bit0 of REG[0x35] on 913Q is "1". What does the REG[0x35] mean?
Thank you.
Tony