Part Number:LMX2541
Hi,
I'm working on using the LMX2541 for an FSK implementation. I am attempting to use a baud rate of 1 Mbps, so I have consequently made the bandwidth at about 2 times that, centered at about 978MHz. When I attempt to run it, there's output in the range of +-7MHz approximately, resulting in an output similar to that of a bandpass filter in that range. Is this because the LMX2541 is unable to run at that baud rate, or is there another reason for it? Is there a max baud rate? When we run the same code on an older revision of the board we are testing, it seems to run fine as long as we do not run it at a high baud rate.
Please let me know if there is any other information needed in order to properly answer this question.
Thanks!