Hi,
I have been trying to perform the Impedance Track learning cycles on my bq20z65EVM. I charged the pack to full and clicked automate steps 2-4 in bqEASY. While it is waiting to stabilize (2 hours) the charge and discharge FETS are open, and there is measured current across Pack+ Pack-. However, after these two hours, I connected a load across Pack+ and Pack-. After doing so, I received a terminate discharge alert, and got discharge fault bits set, the FETs turned off and no current is flowing to Pack+ and Pack-. How do I complete this learning cycle if I cannot discharge the batteries? What is wrong with my method of doing the learning cycles. I've tried looking through documentation for a step by step description of what to do for these learning cycles, but have found nothing. Thanks in advance,
Dylan