Hi,
I am using eZdspTM F2812 Board and CCS Version3.1 for doing my project. I had connected the target and run the program without any errors.
I don't know why, but now i am not able to connect to the target. When i try to connect the target, i got an error message like this,
"Error connecting to the target:
Error 0x80000200/-1031
Fatal Error during: OCS,
Device driver: Problem with the Emulation Controller.
It is recommended to RESET EMULATOR. This will disconnect each
target from the emulator. The targets should then be power cycled
or hard reset followed by an emureset and reconnect to each target.
Sequence ID: 0
Error Code: -1031
Error Class: 0x80000200
I/O Port = 378
Board Name: F2812 eZdsp
Cpu Name: cpu_0
Abort: Close Code Composer Studio.
Retry: Try to connect to the target again.
Cancel: Remain disconnected from the target
Diagnostic: Run diagnostic utility."
Can you please help me to solve this error?
With regards
Devisree Sasi