Hi,
I have purchased an individual Wireless Connectivity Development Kit (CC2540EMK-USB) and inside it only has an CC2540 USB Dongle. It comes with pre-programmed software that lets the dongle operate as a Bluetooth low energy packet capture device for the SmartRF Packet Sniffer.
What I actually need is to have the dongle act as the TI CC2540 Low-Power RF to USB CDC Serial Port. So reprogrammed the dongle using the CC debugger (SmartRF Flash Programmer) with CC2540_USBdongle_HostTestRelease_All.hex file that comes with the TI ble stack.
It was successful but somehow when I connect the dongle to my PC, it cannot be detected and I'm getting Hardware Missing ID message. It says need to contact the manufacturer. I was not able to capture the full message of it.
Does anyone encounter this error before? Any advice?
Appreciate any comments and advice. Thanks.