Part Number: LAUNCHXL-CC1352P
I'm trying to connect a LAUNCHXL_CC1352P1 board (HW Rev A) to SmartRF Studio 7 ver 2.8.0 over USB. SmartRF Studio detects the XDS110 debug probe properly, but fails to connect to the device, giving the error message I've posted below. I am able to flash and debug (use step, breakpoints, etc) this board over USB using CCS ver 8.3.00009. The jumpers are in the default position, do they need to be changed? Also, I've made sure that CCS is closed when I try to open SmartRF Studio.
