CCS/TMS570LS1224: TMS570LS1224 :SPI

Part Number: TMS570LS1224

Tool/software: Code Composer Studio

         as given in the datasheet to configure the L3GD20H sensor as SPI interface CS must be low (1: I2C mode; 0: SPI enabled)

i connected CS of L3GD20H to pin J9.3 (MIBSPI1NCS[0]) is it right to configure CS to be low (from SPI1 select SPI1 port  enable DIR of SCS[0] and DOUT =0)

or their is another way to do that

Best Regards