I have two development environments (miles from each other), and One can connect to my target, the other cannot.
Environment 1 (working):
WinXP (SP2)
PP Wireless Configurator v1.4.2 (Build ID 38775)
PP Wireless Configurator identifies the debugger as:
CC Debugger (0x5646) Programmer Revision 14
Further, it reports (correctly) it is connected to a CC8520 (0x2025373E) Device Revision 2.0
Environment 2 (not working):
Win7 (SP1) (32bit)
PP Wireless Configurator v1.4.2 (Build ID 38775) (same as above)
PP Wireless Configurator identifies the debugger as:
CC Debugger (0x8662) Programmer Revision 25
Further, it reports it is "Disconnected"
Pressing the reset button on the debugger causes the following:
Windows makes a noise (device disconnect),
Configurator removes the debugger from it's list
when I release the reset button, Windows again makes a noise (device connect)
Configurator relists the debugger.
Both environments are using target boards made from the same manufacturing batch.
I got 2 out of 2 to work fine in environment #1
2 out of 2 do not work in environment #2.
Can someone help me get the second one working?
Do I have to put the older firmware into the newer debugger?
Thanks, Mark.