Hi,
By following the same Bond Set Param and HCI Commands, now I cannot able to pair a RF board with a PC Application.
When we are trying to connect with PC application with CC2540 USB dongle and Smart RF Board with CC2640, the connection has been done successfully. For Pairing procedure we are done the following steps.
In CC2640, RF board has been flashed from Simple BLE central project initialize as Peripheral.
Pairing Mode = GAPBOND_PAIRING_WAIT_FOR_REQ
GAPBOND_MITM_PROTECTION = Enabled
GAPBOND_BONDING_ENABLED = Disabled
GAPBOND_IO_CAPABILITIES = Display only
In PC App with CC2540 USB Dongle initialize as central role,
Pairing Mode = GAPBOND_PAIRING_DONT_WAIT_FOR_REQ
GAPBOND_MITM_PROTECTION = Enabled
GAPBOND_BONDING_ENABLED = Disabled
GAPBOND_IO_CAPABILITIES = Keyboard and Display
But, the Authentication has been end with failure as wrong passkey.
Since we have to exchange the passkey as displaying in RF board and enter the value in PC application to pair the devices.
Kindly help me on, to understand the issue and guide to make the Authentication success with proper Passkey exchange.
Regards,
Ramesh Kumar