DCA1000EVM: online processing of raw data from DCA1000EVM

Part Number: DCA1000EVM

HI, 

In a previous post https://e2e.ti.com/support/sensors/f/1023/t/730469?tisearch=e2e-sitesearch&keymatch=dca1000%25252520simultanous, it was mentioned that it's possible to write a script which reads the Ethernet interface for LVDS data, and I wanted to ask what's the sensor configuration needed to automatically trigger the sending of the UDP packet over ethernet during startup of them AWR1843boost sensors.

I tried to activate the lvds streaming like mentioned in the mmwave sdk user guide in Table 1: mmWave SDK Demos - CLI commands and parameters.

here a copy of my configfile:

but this doesn't seem to work: the data_tran_prg led is not blinking and when checking with wireshark, no UDP packets were sent.   

Thank you for your help,

Best regards,

Amine