Part Number: TMS570LS3137
Tool/software: Code Composer Studio
CCS Version: 8.2.0.00007
Spectrum Digital XDS560V2 STM
I've successfully installed the drivers for the above configuration and connected the emulator tail to my target using the MIPI 60 to CTI20 adapter. (Note that I have been connecting an XDS110 debug probe to this same target interface without difficulty for quite some time.)
When I open the target configuration for XDS560 and run Test Connection, I get the following results. Where have I gone wrong? Yes, the target is powered. See attached target configuration file.
[Start: Spectrum Digital XDS560V2 STM USB Emulator_0]
Execute the command:
%ccs_base%/common/uscif/dbgjtag.exe -f %boarddatafile% -rv -o -F inform,logfile=yes -S pathlength -S integrity
[Result]
-----[Print the board config pathname(s)]------------------------------------
C:\Users\ShaneH\AppData\Local\Texas Instruments\
CCS\ti\0\0\BrdDat\testBoard.dat
-----[Print the reset-command software log-file]-----------------------------
This utility has selected a 560/2xx-class product.
This utility will load the program 'sd560v2u.out'.
Loaded FPGA Image: C:\ti\ccsv8\ccs_base\common\uscif\dtc_top.jbc
The library build date was 'May 30 2018'.
The library build time was '22:02:11'.
The library package version is '8.0.27.9'.
The library component version is '35.35.0.0'.
The controller does not use a programmable FPGA.
An error occurred while hard opening the controller.
-----[An error has occurred and this utility has aborted]--------------------
This error is generated by TI's USCIF driver or utilities.
The value is '-183' (0xffffff49).
The title is 'SC_ERR_CTL_CBL_BREAK_FAR'.
The explanation is:
The controller has detected a cable break far-from itself.
The user must connect the cable/pod to the target.
[End: Spectrum Digital XDS560V2 STM USB Emulator_0]
(Please visit the site to view this file)