Part Number: AWR1642
I am running mmwave studio along with the AWR 1642 and the DCA1000 EVM.
Last week, I installed mmwave studio, and the radar api showed up, as did all of the Dev pack, communications, and XDS110 ports. Today, I opened mmWave studio once again, but only the XDS110 ports show up. I have in fact installed the FTDI drivers. What's more, I can't get Radar API to show up, even though radar API showed up last week.
I just wondered if this has anything to do with the fact that even when radar API was showing up last week, when I tried running the DataCapturedemo_xWR.lua as instructed by the DCA1000 EVM quick start guide, not only did the file fail to run, in radar API it said that both RS232 and SPI were disconnected. However, it did show the FTDI as "connected."
Thank you.