BQ40Z50-R2: Temperature Calibration

Part Number: BQ40Z50-R2

Hello.

I have two issues with the bqManagement Studio software.

1. I am trying to calibrate temperature. Temperature Enable is set to 12 and Temperature mode is set to 10.

When I attempt to calibrate I get the error message "Calculated external sensor two temperature correction is out of range".

2. The help instructions indicate there is an "Advanced Calibration" Page I can only bring up the "Basic Calibration Page".

I have a 10k NTC Thermistor to the TS4 pin and another one on the TS1 pin.

Any help is appreciated.

Thanks