Part Number: TPS65381A-Q1
Hi,
My customer would like to reset and reload the codes for MCU when 65381 is in Active, the reloading takes several minutes, during the reloading there is no watchdog signal(They use Trigger Mode), so 65381 will go to SAFE mode with WD_FAIL_CNT=7+1 & WD_RST_EN=1 then Reset then Diag, then set DIAG_EXIT_MASK to stay in DIAG. However, to go to SAFE mode it needs several bad watchdog which takes too long time, so they asked, if we have quicker method to disable watchdog in active mode(By setting WD_RST_EN=0?), to keep 65381 in active mode even without watchdog, or if we have quicker method to go to Diag mode from Active?